Install & Set 3M QS1000 - MK2 AT9000 Passport Reader Driver                     

Virgo Technical Support team welcomes all inquiries and is ready to provide free technical support to install and set the reader, through direct access to technical support:

http://alturl.com/vfzmc

Define the electronic reader within the computer:

then the application Run as administrator 

Follow the steps below

From start menu, we write 3M and choose 3M Reader Expo

As shown below screen

We go to path D:\Virgo\VirgoOffline1438,create folder and name it Data

Then right click folder Data and choose properties

From tap Security choose your user and click Edit, give your user the permission for authenticated user is Full control and click OK

From 3M Reader Expo screen choose Change Save Directory from Image menu, and choose folder Data then click Open

From Image menu choose Image Encoding > JPEG, and check Save All

From Scheme menu we choose for example QS1000 then click Select

then from tap Selected Panels we need to following options:

- Document Summary 

- ePassport : when exist RFID but in QS1000 not exist, so not check option.

- IR Image

- Machine Readable Zone

- Visible Image

Then click Save Changes and click Select

When this becomes the reader state is Enabled as shown below screen

Try now read a passport, we will find that it's read as shown following screen

Note: If the RFID chip image isn't read, we make sure the Capture minimal RF data, using DG1 and DG2 option is activated on tap Scheme Options

Finally, we go to the System settings Virgo Offline from Other menu

from tap General choose Reader Path D:\Virgo\VirgoOffline1438\Data and Passport Reader type is 3M Full Page also, we choose External Reader Application then click OK